Our vintage-inspired colors
Nitorlack colors are based on the original Fender and Gibson colors. The creation of these colors is preceded by a great work and exhaustive study by our laboratory and technical department. Thanks to this we have been able to recreate with fidelity the tones of the Fender and Gibson guitars of the 50’s and 60’s.
During those years up to the present day it should be noted that the colors of vintage guitars have varied greatly over the years due to the aging of the nitrocellulose lacquer and modifications in the colors of the brands.
Therefore, two guitars finished in 1960 with fender colors may be totally different from each other or from a more current guitar.
- We start applying the color once the guitar has been dabbed with Nitorlack Primer.
- When we start the painting work, the pores must be closed and the grain must not be marked.
- Apply the product either by spray or spray gun to a distance of 25 cm.
- When applying we must follow a pattern of application, first horizontal and then vertical, applying the paint uniformly.
- Apply several coats, letting dry between them about 24 hours and sanding between them, to remove any remaining impurities.
- This work will be finished when the surface is completely smooth and free of imperfections.
Frequently Asked Questions:
How many sprays do I need to varnish a guitar?
– If the surface is well covered and it is not your first painting project, you will be able to do it with a spray, although you will not apply many coats. However if you are not an expert we recommend using 2 sprays for an optimal finish.
What temperature should the guitar be at during and after the process?
– It is recommended to do it in a place whose temperature is between 15 and 25 degrees. If the painting or varnishing process is done in very hot or cold conditions, the final result may not be good.
Where should I carry out the process?
A clean site will be essential to prevent dirt or dust particles from adhering to the surface.
Is sanding between coats mandatory?
No es algo que deba siempre, pero es recomendable para así eliminar las imperfecciones que queden en la pintura al final de cada capa, así como las partículas que puedan adherirse.